Nov 13

Würker 3D Puffy Foam: Settings, Colours and How to Use It

3D puffy foam creates raised, sculpted embroidery. The foam is laid loosely on the fabric, covered with satin stitch and then torn away. Würker 3D Puffy is 3 mm thick, in a firm quality and available in six colours: to the foam in the ZSK Parts Shop.

What it is suited for
Firm, stable textiles: structured caps, twill, denim, canvas, jackets, bags and emblems.
It is not suited for thin, stretchy or fluffy fabrics, or for fine lettering, script fonts and small details.

Why firm foam?
Firm foam is compressed less by the satin stitch. The height stays, edges and outlines become sharper. It perforates cleanly and tears away with little residue. That is why hard foam is the recommendation for caps and emblems.

Practical values
• Satin width: about 3 to 12 mm
• Density: roughly double, stitch spacing about 0.16 to 0.20 mm
• Underlay: none, it presses the foam down
• Fill stitches: do not use, they destroy the effect
• Column ends: close with cross stitches
• Speed: about 500 to 750 stitches per minute
• Needle: 75/11 or 80/12, new and sharp
• Foam: do not hoop it, just lay it on
• Leftovers: tear off, then tweezers, then hot air
Use hot air only with 100 % polyester thread. Cotton and viscose burn. These are guide values, always stitch a sample.

How it sits in the hoop
From top to bottom: foam (laid on only), fabric, backing. Only fabric and backing are hooped.

Why six colours?
Tiny foam residues always remain between the stitches and along the edges. If the foam colour matches the thread, you do not see them. With red on red, white foam is a visible flaw. The rule: match the foam colour to the thread colour. Available in white, black, red, blue, green and yellow.

Learn more
Step by step: 3D puff embroidery on caps. On video: the free course 3D Puff on Caps. The matching backing: Würker backing overview.

Frequently asked questions

How thick is Würker 3D puffy foam?
3 mm. That is the standard thickness for 3D embroidery on caps.

Which colours are available?
White, black, red, blue, green and yellow. The foam colour should match the thread so that small residues stay invisible.

Is the foam hooped?
No. Fabric and backing are hooped, the foam is only laid on top.

Which density do I need for 3D puffy foam?
About double the density of a normal satin stitch, a stitch spacing of roughly 0.16 to 0.20 mm, without underlay.

How do I remove foam leftovers?
Tear off first, then tidy up with tweezers, finally apply hot air briefly. Hot air only with 100 % polyester thread.

Where can I buy Würker 3D puffy foam?
In the ZSK Parts Shop.