Nov 13

Upper Thread Keeps Breaking? The Most Common Causes and Fixes

Every thread break costs time: the machine stops, you rethread, back up and continue. If the upper thread breaks again and again, it is almost never bad luck. Work through the causes in this order, from the simplest to the most involved.

1. The needle
A blunt, bent or wrong needle is the most common cause. Depending on the material, a needle lasts about 8 operating hours. Change the needle before you touch the tension, and check that it is inserted the right way round and all the way up.

2. The thread path
Is the thread threaded correctly, does it run through every guide, is it caught anywhere? A cone that unwinds badly or a knot in the thread is enough.

3. Thread tension
If the upper thread tension is too high, the thread breaks. Guide values: 80 to 100 cN at the needle eye, bobbin thread 25 to 35 cN at the bobbin case. Always set the bobbin thread first, then the upper thread. On the back of a satin column the bobbin thread should take up roughly the middle third.

4. Thread and needle do not match
For 40 weight thread a needle size NM 70 to 75 is usual, for fine 60 weight thread NM 60. Metallic threads need a larger eye. Old or badly stored thread becomes brittle.

5. The embroidery file
Too much density and very short stitches make the needle penetrate the same spot again and again. If the thread always breaks at the same place in the design, the cause is the file, not the machine.

6. Speed and material
With thick materials, 3D foam or metallic thread it helps to reduce the speed. Adhesive from spray glue or sticky backing on the needle also causes breaks.

Quick checklist
• Needle new and inserted correctly
• Thread path clean, cone runs freely
• Tension checked with the rule of thirds
• Needle size matches the thread
• Design checked for density and short stitches at the break point

The free course The Embroidery Starter Kit covers the basics of needle, backing and tension.

Frequently asked questions

Why does my upper thread keep breaking?
Usually the needle is blunt or wrong, the thread is not threaded cleanly or the upper thread tension is too high. Check in this order before you change the embroidery file.

How often should I change the embroidery needle?
As a guide after about 8 operating hours, earlier with abrasive materials. With thread breaks, changing the needle is always the first step.

What is the correct thread tension?
Guide values are 25 to 35 cN for the bobbin thread and 80 to 100 cN for the upper thread. On the back, the bobbin thread should cover about a third of the column width.

The thread always breaks at the same spot. Why?
Then the embroidery file is almost always the cause: too much density, stitches that are too short or too many layers on top of each other.

Does metallic thread break more often?
Yes, it is more delicate. Use a needle with a larger eye, reduce speed and tension and avoid very short stitches.