Nov 13

How to Set Thread Tension on an Embroidery Machine: the Rule of Thirds

Loops on top, visible bobbin thread or thread breaks: thread tension is behind many embroidery problems. One simple rule and the right order get it under control.

The goal: the rule of thirds
Turn a satin column over. On the back, the bobbin thread lies in the middle and takes up about a third of the width. To the left and right you see a third of upper thread each.

Three pictures
• Correct: bobbin thread centred, about a third
• Upper thread too tight: the bobbin thread is pulled up and shows on the front
• Upper thread too loose: the bobbin thread is too narrow on the back, the upper thread forms loops

The order: from bottom to top
Always set the bobbin thread first, then the upper thread.

Bobbin thread: 25 to 35 cN
Measured at the bobbin case with a spring gauge or a tension meter. The tension spring in the bobbin case is delicate, so turn the screw in small steps only. Pre-wound bobbins run more evenly and are easier to set.

Upper thread: 80 to 100 cN
The upper thread tension is spread across three stations: pre-tension, main tension and the tension roller. You measure the sum at the needle eye, pulling downwards.

When to readjust
After changing to a different thread weight or material, with metallic and effect threads, for 3D embroidery and whenever the stitch picture changes. The values are guides and must be adapted to machine, thread and material.

Step by step on video: the free course The Embroidery Starter Kit.

Frequently asked questions

How do I recognise correct thread tension?
On the back of a satin column: the bobbin thread lies in the middle and takes up about a third of the width.

What if the bobbin thread shows on top?
The upper thread tension is too high or the bobbin tension too low. Check the bobbin thread first, then reduce the upper thread tension.

Why do loops form on my embroidery?
The upper thread is too loose or the bobbin thread too tight. Tighten the upper thread slightly or loosen the bobbin thread.

Which values apply to thread tension?
As a guide 25 to 35 cN for the bobbin thread at the bobbin case and 80 to 100 cN for the upper thread at the needle eye.

How do I measure thread tension?
With a spring gauge or a tension meter. The meter is faster and gives repeatable values.